Atendimento: 31 3371-4506/ 99983-2308


To learn how to build your R6 interface, the current documentation is listed in the instruction manual while legacy gear can be found in the Knowledge Base document CI-V Reference.

100 kHz – 1309.995 MHz* wideband coverage While the IC-R6 receives an ultra wideband frequency range, the radio provides superior sensitivity and reciever characteristics that is insusceptible to interference. Amateur stations, AM, FM, short wave broadcasts, TV audio* and a variety of utility communications can be caught and listened to. 

Frewuency range depends on version. Analog TV auido only. Cannot decode digital TV audio.

100 channels per second high speed scan The IC-R6 has 100 channels per second high speed scan capability*. This superior scanning power allows the utmost efficiency when search over 1300 MHz of spectrum!

VFO mode

15 hours of continuous receive capability*
The IC-R6 is energy-efficient, designed to provide many hours of listening enjoyment on a

single charge. With the supplied rechargeable Ni-MH cells (1400mAh × 2), the IC-R6

provides up to 15 hours of continuous receive capability*.
At 50 mW output using external

1300 memory channels with 22 memory banks
With 1300 alphanumeric memory channels, 50 scan edges and 200 auto write memories, the

IC-R6 gives you flexible scanning. Use the bank link scan feature to choose from and connect

any of the 22 memory banks.
VSC (Voice Squelch Control)
The VSC opens the squelch only when a modulated signal is detected and ignores

unmodulated beat noise. It is a handy feature for those listeners who are scanning for talk,

news and music, but not data bursts or beacons.
Multiple power choices
The IC-R6 can be powered by rechargeable Ni-MH cells, or with alkaline batteries. Run the

IC-R6 using the AC adapter, BC-196S, or opt for a cigarette lighter cable, CP-18. When used

the optional drop-in charger stand BC-194 with the AC adapter or cigarette lighter cable, you

can easily start charging the Ni-MH cells, while eliminating the need to connect the power

source to the DC power jack of the receiver.
Other Features
Built-in audio low pass filter
±1.0ppm high frequency stability (at 25°C)
Earphone cord antenna for AM broadcast
Ferrite bar antenna for AM broadcast
150mW loud audio with internal speaker
DTCS and CTCSS tone squelch and reverse tone squelch
Priority watch function with priority beep function
Optional CT-17, CI-V level converter for remote control
PC programmable with optional CS-R6
Receiver-to-receiver cloning (optional OPC-474 required)
Auto power OFF (0.5-2 hours and end of busy signal)
Compact, dip-resistant construction
Duplex operation monitoring
Automatic LCD backlight
Dial speed acceleration
Built-in RF attenuator
Auto memory write scan stores the detected frequency, mode and tone into a specified

Reversible up/down buttons and dial knob for volume, frequency, memory channel, scan

direction and set mode settings
Optional new tube earphone, SP-27
Weather channel receive with weather alert (USA version only)

Endereço e Localização

Av. Francisco Sá, 787 / 508 - Prado - Belo Horizonte - MG  - CEP 30411-174